Robots That Inspect. Records That Prove It.
A robot walks your inspection rounds and records every gauge, panel and room, so you can prove the work was done and fix problems before they cause downtime.
A checked box is not proof.
Most facilities still close an inspection round with a checkbox, a radio call or a folder of photos nobody reopens. The room was walked. Nothing shows what was actually seen.
A
Rounds get missed
Shift changes and long routes mean some checkpoints quietly get skipped, and nobody can tell which ones.
B
Logs say done, not what was found
A tick on a sheet cannot show the reading, the photo or the time it was taken.
C
Problems grow between rounds
A loose connection or a failing condenser shows up as heat long before it trips an alarm.
A robot walks the round, the same way every time.
A FacilityOps inspection robot follows a set route through your rooms on your schedule, day or night. It runs fully on its own, and your technicians can take over at any time.
Step 1
Set the route
We map your rooms with you and agree on the checkpoints that matter: switchgear, UPS, cooling units, generators, egress doors.
Step 2
The robot runs it
On every round it stops at each asset and holds the same position and angle as last time.
Step 3
Every stop is captured
So this week can be compared with last week, checkpoint by checkpoint.
Watch the Robot Run a Route
Sixty seconds of an autonomous mobile robot working a live server room, stopping at each checkpoint, capturing across every sensor, and recording what it finds.
Everything a technician checks, recorded.
One plug-and-play sensor hub carries the full kit, and smaller hubs fit rooms and cabinets a robot cannot reach.
Want the detail on the robot and every sensor? See how it works.
Every round becomes a record you can check.
Findings, sorted
What is normal, what changed and what needs attention, each with its photo, reading and location.
A tamper-evident record
Every capture is checked and time-stamped. If anything is changed later, the record shows it.
Any two rounds, compared
See what changed since last week, room by room and asset by asset.
Act on it the same day.
Fix it while it is small
Findings turn into work orders, so a warm breaker gets fixed before it becomes an outage.
Hand the auditor the proof
Records come organized for NFPA 70B, NFPA 110, ASHRAE 180, OSHA and the other standards your site answers to.
See every site and shift
Know which rounds ran, which checkpoints were missed and where risk is building.
Proven in a live data center.
At the CRSC Data Center, powered by Solutions IS, in Houston, the robot’s thermal camera spotted a failed condenser 4.5 hours before the facility’s sensors alarmed. The unit ran 7.2°F warmer than the working one, and CRSC repaired it promptly.
Why Teams Replace Manual Inspections
See how a standardized autonomous inspection workflow improves consistency, visibility, and audit readiness.
Manual Inspections
- ✕Paper or spreadsheet records
- ✕Manual reporting
- ✕Difficult audit preparation
- ✕Limited inspection visibility
- ✕Missed or inconsistent inspections
- ✕Slow issue identification
FacilityOps AI
- ✓Verified digital inspection records
- ✓Automated documentation
- ✓Audit-ready records anytime
- ✓Real-time operational visibility
- ✓Standardized inspection execution
- ✓Faster issue detection and response
See what FacilityOps would do for your site.
Get the one-page overview: what the robot checks, what you get back, and how a pilot works.
I’d like to explore my options
No sales call unless you ask for one.